Publicidad
Idiomas disponibles
Idiomas disponibles
the device, or connect and disconnect to the supply mains with the hands and / or feet
wet. Do not pull on the connection cord in order to unplug it or use it as a handle Unplug
the product immediately from the mains in the event of any breakdown or damage and
contact an official technical support service. In order to prevent any risk of danger, do not
open the device. Only qualified technical personnel from the brand´s Official technical su-
pport service may carry out repairs or procedures on the device.
B&B TRENDS SL. disclaims all liability for damages that may occur to people, animals or ob-
jects, for the non-observance of these warnings.
INSTALLATION
1,8m
20cm
20cm
Drill two holes in wall and have a distance of 1.8m from the ground. The diameter of the hole just
contained the inflated plastic pipe. After tucked the inflated plastic pipe, fixed pothook on the
pipe with screw. Make sure pothook fastness and hang the heater. The clip under the pothook
should be inserted rabbet of the heater bottom.
Function operation (both machine & remote control):
1. Plug in and switch on by pressing the red switch 0/I, enter into standby mode and display
shows (fig 1)
2. Press"
" button for one time, enter into fan mode and the display show "--"(photo A) . Press
second time , the product works in low heating and display shows like photo B Press third time,
changes to high heating and display shows like photo C , then Press fourth time , enter into in
standby mode and display shows"--"like photo A. the cool fan will work for 30seconds and en-
ter into standby mode. (Figuer 2)
3. Press "
" button to set timer(00-12hours). Pressing the button one time increases one hour
for timer. After setting time, the display will show current setting time for 5 seconds, then resu-
me to previous display, meanwhile the light of " " will on. Below photo is an example of setting
8h: (Figure 3)
4. Appointment "ON": In standby mode, press "
" timer button, you can set the appointment
turn-on time in 1-12 hours. After complete setting, the display shows the appointment turn-on
time and also the light " " is on. The display automatically decreases 1 hour for each hour pas-
sed. When the appointment power-on time arrived, the product will automatically turns on. The
default setting temperature is 23 ºC during appointment turn-on. Below photos is an example
to set appointment turn-on time to 8 hours:
Note: If not setting the temperature and weekly program, the product will automatically turn-
off after 12 hours of continuous work, and enter into standby.
21
Publicidad
