Sharp SJWX830FWH Manual De Instrucciones página 7

Description
9 way shelf
• There are nine ways to use this shelf.
Tall food
Large food with depth
• You can use the left side shelf in the same way.
Note
• Do not take off only one side of the shelf from the
partition.
Fixed partition becomes unstable and it may fall down.
• Do not apply weight on the fixed partition by leaning
food, etc.
The shelf may not move correctly and it may fall down.
Fixed partition
• Do not place food only at the back side of the shelf,
when the front shelf is pushed in. (Because the shelf
may rotate)
• Do not use the shelf
with the front shelf half-way
on the rail.
(It may fall down from the rail)
Pull it out until it
engages to the tab.
Rail
Tab
Lift the front part
of the shelf up and
push it in.
Bring the shelf up to
the back.
Motion sensor
• The control panel and LED indicator light up
automatically when the sensor detects your motion.
(Including pets.)
• If your motion has not been detected, the control panel
turns off in approximately 1 minute.
• This sensor detects the changes in infrared (heat).
The control panel lights up when the sensor detects the
change even though you are not around. The sensor
does not react if you stay still in front of it.
• Motion sensor is located at the bottom of the left side
refrigerator door. The sensor may not react depending
on your standing position or temperature differences
between ambient temperature and body temperature.
• The sensor may not react when illuminated with direct
sunlight.
Detection area
• Detection area is shaded part below.
The sensor reacts when you approach the area within
approx. 50cm from the refrigerator.
Door Alarm
• The door alarm sounds when the door* is left open.
• The door alarm sounds in 1 minute after opening the
door and again after 1 minute (once in each case).
• If the door* is left open for approx. 3 minutes, the alarm
sounds continuously.
• The alarm stops after closing all the door.
( * Only refrigerator door and left freezer door.)
Deodorizing unit
• Deodorizing catalyst is installed on the routes of cold air.
No operation and cleaning are required.
EN
EN-5