cecotec DRUMFIT SITBIKE GEL Manual De Instrucciones página 7

NOTE:
the graphics in this manual are schematic representations and may not exactly match the
device.
1. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the Official Cecotec Technical Support Service
immediately.
2. PRODUCT ASSEMBLY
WARNING: compatible with all saddle posts with 7 mm diameter rail and with saddle posts
with 23 mm tube diameter.
- Insert the saddle into the saddle post and position it correctly.
- Then, tighten the nuts located on both sides of the bracket under the saddle. When
tightening the nuts, tighten to the same torque on both sides.
- Once the saddle is securely fastened to the saddle post, it is not necessary to tighten the
nuts any further.
Warning: do not continue to tighten the nuts when they are securely in place. Otherwise, the
saddle could slip.
Fig. 1
3. CLEANING AND MAINTENANCE
Basic cleaning:
- To keep the saddle in optimum condition, regular cleaning is recommended.
- A soft, damp cloth should be used to clean the saddle surface.
ESPAÑOL
DRUMFIT SITBIKE GEL
7