Beyerdynamic MMX 200 Manual De Uso página 5

MMX 200 wireless
CONNECT THE USB CABLE
When connecting the provided USB-C to USB-A
�
cable, the USB-C is connected to the headset,
while the USB-A is connected to the device
(e . g . computer / console) .
For devices with USB-C ports, please use a third party
�
USB-A to USB-C adapter or cable .
� Once the headset is connected, it will automatically
install the driver . This may take a few seconds .
Please check your system audio settings and select
�
the MMX 200 wireless as input and output device, if
it's not already selected .
If you want to use the headset as a USB audio device,
�
switch it off and connect it via USB . The headset will
start automatically and is ready as a USB device .
� If you want to charge the headset during wireless
operation, connect it to the PC . This does not affect
the wireless connection, but the headset is not
available as a USB audio device .
CONNECT THE JACK CABLE
Connect the USB-C connector to your headset and
�
the jack plug to your device . The output signal should
now be played back by the MMX 200 wireless, as well
as input signals that will be picked up by the micro-
phone .
Please switch on the headset! Only after switching
�
on, the headset is also active in analogue mode .
When connecting to a computer, please also
�
check your system audio settings and select your
computer's sound card as input and output device .
Caution: Connect the jack plug of the cable
�
to a headphone socket only! If you connect the
headset to any other jack socket, the headset
could be damaged .
Connect to
headset
Connect to
headset
5
Connect to device
Connect to device