Beyerdynamic MMX 200 Manual De Uso página 8

MMX 200 wireless
AUGMENTED MODE
Using the Augmented Mode, your headset works
�
as if it were open, i . e . you can hear your voice more
natural and you can hear your surroundings such
as people talking to you or the doorbell .
Press and hold the control wheel (2 seconds) .
�
The Augmented Mode is enabled when you hear the
�
voice prompt . The light guide around the
control wheel will illuminate turquoise .
To disable the Augmented Mode, press and hold
�
the control wheel again for 2 seconds . The turquoise
light will go off .
Press
2 sec .
LOW LATENCY MODE
By default, the MMX 200 wireless is supplied in Low
Latency Mode .
This mode is suitable for gaming on devices with USB
connection (PC, PlayStation®, Nintendo Switch™) .
Connect the dongle to the USB connection of the
�
device (PC, PlayStation® Nintendo Switch™) .
When the headset is in Bluetooth® Mode:
�
Press the / button twice briefly to switch to the
Low Latency Mode .
� If the supplied dongle is lost and a new dongle is to
be used, it must be paired with the headset .
You can find more information at:
support.beyerdynamic.com
BLUETOOTH® MODE
Before the headset can be used in Bluetooth® Mode,
it must be paired with a mobile phone or another
Bluetooth®-enabled device .
The pairing prodcedure can differ between various
devices .
Please refer to the operating instructions of the
�
device with which the headset is to be paired .
When the headset is in Low Latency Mode:
�
/ button three times in rapid
Press the
succession to switch to Bluetooth® Mode .
Select MMX 200 wireless in the pairing list on the
�
mobile phone or other Bluetooth®-enabled device .
Once the headset is connected, audio and tele-
�
phone functions are available via the
Please refer also to the "Operating functions/
operation" table .
HYBRID MODE
For Hybrid Mode: Whilst the headset is in Bluetooth®
Mode, it is connected via a mini jack (3 .5 mm) to an
analogue headphone output (e . g . controller) with the
optional analogue cable . The audio signals from
Bluetooth® and the analogue device are mixed 50/50 .
Whilst the headset is in Bluetooth® Mode, connect
�
the headset to the headphone output (e . g . controller)
with the analogue cable .
� If the cable is disconnected from the device, the
headset switches to the Bluetooth® Mode or
connects to the dongle, if no Bluetooth® connection
has been active before .
When Bluetooth® is disconnected, the headset
�
operates in the analogue mode .
Please control the volume of the Bluetooth® and
�
analogue source (e . g . game console) directly on the
analogue or Bluetooth® device .
8
/ button .