WolfPack HRH24S Manual De Instrucciones página 53

5. Install gun holder and power cord holder.
On the left of the machine, slide the gun hook A on the upper of the handle and slide
the gun hook B on the lower of the machine.
Slide the power cord holder on the right of the machine.
6. Screw the high pressure hose onto the water outlet pipe.
Push and turn (clockwise) it tight to avoid leakage. When the pieces are joined
properly, you cannot separate the two components by pulling straight out from the
water outlet.
CAUTION: Prior to operating the machine, please ensure that the high pressure
hose has been completely uncoiled.
Whilst the machine is in operation, the high pressure hose MUST NOT loop.
7. Attach the other high pressure hose to the gun.
Note: After the high pressure hose is connected, check the connection by gently
pulling on the hose to ensure it stays connected. Push the lock button and pull to
detach the high pressure hose.
For detaching the hose easily, please pull the trigger to drain water from the wand
when operation is completed and move the switch to the" OFF/0 "position.
Push button to remove the hose
53