WolfPack HRH24S Manual De Instrucciones página 54

8. Attach the water inlet connector&inlet hose
Remove the plastic plug from the machine's water inlet hose, screw the water inlet
fitting onto the water inlet, then insert the 1/2 quick connect into the water inlet fitting,
then connect one end of a home inlet hose (not supplied) to the quick fitting connect
the other end to the water source.<<<If the water inlet connector has been
installed, skip the steps for installing the water inlet connector.>>>
WARNING: The appliance is INTENDED to be used at a temperature above 0 degree.
WARNING: Garden hose can not be damaged and leak, Inner diameter less than
1/2 "inches, the length can not be greater than 8m.
9. Connect to the power supplier, Plug the pressure washer into the power outlet.
54