WolfPack HRH24S Manual De Instrucciones página 58

4. To wash with detergent
Rotate the pot body and the spout apart, then add water with a properly prepared
cleaner or detergent, pour it into the pot body and close it. Finally attach the detergent
bottle to the gun.
a. Squeezel the wand trigger, detergent will come out through the nozzle.
b. Apply detergent so it thoroughly covers cleaning surface.
c. Allow detergent to remain on the surface for a few minutes. This is a good time to
use a brush to lightly scrub heavily soiled areas.
d. Change to spray nozzle, Rinse detergent from surface.
e. Cleaning up: Always draw fresh water through the detergent bottle when done to
flush any remaining detergents from the injection system. The bottle could be
detached if necessary in this process.
MAINTENANCE
Any maintenance operations not covered by this chapter should be carried out by an
Authorized sales and service centre.
WARNING-DANGER!
Always disconnect the plug from the power socket before carrying out
any work on the appliance.
1. Cleaning of water inlet filter
The water filter was installed inside the water inlet connector, should be cleaned
periodically. Rinse it with clean tap water, and then place it back into the water inlet
connector.
2. Cleaning the nozzle
Using the nozzle tip cleaner provided (or an unfold paper clip), insert the wire into the
nozzle hole and move back and forth until debris is dislodged. Back flush water
through the nozzles using garden hose and highest pressure available (either standard
water nozzle or use your thumb over the nozzle to create water pressure for back flush)
NOTE: Detergent need to be diluted to achieve
the most effective cleaning. it is recommended
to dilute the detergent in a suitable container
to the required concentration before using.
58