Publicidad
Idiomas disponibles
Idiomas disponibles
Program selection
For optimum drying results your dryer
offers several program groups and
additional options.
Select the required drying program
from the program table according to
the examples (see page 15).
Automatic
programs
There are automatic programs for
different types of textiles.
(Regular/Cotton or Permanent Press).
Regular/Cotton
01l
40 rni
20rain
Time Dry
Permanent
Press
Off
I
Airflu if/N° heat
I
20 rain
TimeDry]
The program sequence of automatic
programs is controlled via sensors. The
duration of the program depends on
the measured degree of moisture in the
laundry and on the selected degree of
dryness (e.g. Damp dry or Extra dry).
Time programs
Time programs run for a specific time
(20, 40, 60 minutes).
In the "Air fluff/No heat" stage the dryer
runs on ambient air without a heat
supply for 20 minutes.
li-1 Dry woolen or wool-rich textiles
with dryer rack only!
Options
Start
Delicates
Signal
Stop
low temp.
@
0
Delicates
low temp.
Press the "Delicates low temp." button
for temperature sensitive textiles.
Observe the care information or
symbols on the textiles. The
temperature of the drying process is
reduced, the drying time is extended.
Signal
Your dryer outputs different signals, if
the "Signal" button is pressed.
Signal
Type
Stalt
Shorttone
End
Sequence d sh0_
tones
Mal-0perati0n
Sequence d 10ng tones
Warningd
Sequence d l0ngtones
malfunction
TIThe
signal
"Warning of malfunction" is active
in any case.
Indicator
of program
sequence
The dryer uses an electronic scanning
system for all programs except the time
programs. A moisture sensor
continuously checks the moisture in the
laundry. Drying ends automatically as
soon as the selected degree of dryness
has been reached.
The drum continues to rotate at
specific intervals for one hour to
prevent creasing.
The current degree of drying and the
level reached during the program
sequence is indicated via indicator
lights (Drying, Damp dry, Regular dry,
Wrinkle block).
I_llf
the indicator light "Wrinkle block"
illuminates when the program
selector is in Off-Position - turn off
the circuit breaker and call for
customer service!
14
Publicidad
