Publicidad
Idiomas disponibles
Idiomas disponibles
Incorrect cleaning may damage the
dryer. Do not spray with a water jet.
Do not use scouring agents or
all-purpose cleaners. Do not use
steam cleaners.
Wipe the housing and fascia with a soft
cloth and soapy water only.
Wipe the drum, door seal and inside of
the door with a damp cloth only.
Cleaning the lint filter
A dirty filter extends the drying time and
increases energy consumption.
The filter should be cleaned before and
after each drying process.
If a warning signal and an E01 warning
message are emitted during a drying
program, clean the filter immediately
and check the exhaust duct.
_i]
The program interrupts
automatically.
1. Switch off the dryer. Program
selector to "Off".
The inside of the door heats up
during the drying process.
2. Open the door.
5. Insert the filter.
6. Close the door.
Cleaning the exhaust
duct
Inspect and clean the exhaust ducting
at least once a year to prevent
clogging. A partially clogged exhaust
can lengthen the drying time.
Turn off the circuit breaker
Pull out power supply plug
Disconnect the duct from the
dryer.
Vacuum and reconnect the duct.
Cleaning the moisture
sensor
The moisture sensor has to be cleaned
because a fine layer of transparent
buildup is deposited on the sensors.
Cleaning the bearing
shield
Over time, fluff from the drying process
collects in the bearing shield.
This fluff can be easily removed using
your vacuum cleaner, at least once a
month.
Change the light bulb
The dryer light turns on inside the drum
when you open the door.
To change the light bulb:
Set program selector to "Off".
Turn off the circuit breaker.
Pull out power supply plug.
Open the door and locate the light
bulb on the upper left side of the
seal.
3. Remove the lint filter.
4. Remove lint by stroking your hand
over the filter.
The filter should be lightly scrubbed
twice a year with warm soapy water.
The filter is cleaned when it no longer
holds water. The filter must be dried
thoroughly before being replaced.
This deposit can easily be removed by
wiping the sensors (the two bars next
to the lint filter) with a cloth and a little
white vinegar.
Use white vinegar only[
Clean the moisture sensor once a
month.
Loosen the screw of the cover and
open the cover.
Turn bulb counterclockwise.
Replace the bulb with a new
appliance bulb only (obtainable
through parts department).
Replace the cover and secure with
the screw.
Plug in dryer or reconnect power
supply.
18
Publicidad
