4. Clean the product. Refer to
for instructions.
5. Do a complete servicing of the product.
Disposal
•
Obey the local recycling requirements and applicable
regulations.
Technical data
Engine
Cylinder displacement, cm
Idle speed, rpm
Maximum engine power acc. to ISO 8893, kW/hp @ rpm
1
Ignition system
Spark plug
Electrode gap, mm
Fuel and lubrication system
Fuel tank capacity, US Pint/cm
Oil tank capacity, US Pint/cm
Type of oil pump
Weight
Weight, kg/lb
Saw chain/guide bar
Type of drive sprocket/number of teeth
Saw chain speed at 133% of maximum engine power
speed, m/s / ft/s.
Recommended cutting equipment
A specific chainsaw model has to be evaluated with
the cutting equipment to be recommended and fulfill the
requirements in ANSI B175.1-2021 (Internal Combustion
Engine-Powered Hand-Held Chainsaws - Safety and
Environmental Requirements) and Canadian Standards
1
Always use the recommended spark plug type! Use of the wrong spark plug can damage the piston/cylinder.
1792 - 007 -
Maintenance on page 19
Technical data
3
3
3
Accessories
•
Discard all chemicals, such as engine oil or fuel, at a
service center or at an applicable disposal location.
•
When the product is no longer in use, send it to
a Husqvarna dealer or discard it at a recycling
location.
®
Husqvarna T540XP
Mark III
39.1
3000
1.9/2.6@10200
NGK CMR7H
0.65
0.66/310
0.49/230
Adjustable
3.8/8.4
Spur 7
26.9/88.3
CSA Z62.1-15 (Chainsaws) and CSA Z62.3-11 (R2016)
(Chainsaw kickback).
Chainsaw model Husqvarna T540XP
safety requirements in ANSI B175.1-2021 and Canadian
Standards Association CSA Z62.1-15 (Chainsaws) and
CSA Z62.3-11 (R2016) (Chainsaw kickback), when
equipped with the below listed saw chain and guide bar
combination(s).
®
Mark III meet the
31