TREND T1 Serie Instrucciones Originales página 19

Setting Depth of Cut on Plunge Base
- (Fig. 20)
The rotating turret stop screws can be used for pre-
setting up to three depths of cut. The height can be
adjusted using a screwdriver and an 8mm A/F spanner.
• Pre-set the 3-way turret stop as required
• Undo the thumb knob for securing the depth stop.
• Unlock the plunge locking lever and lower the machine
slowly until the cutter just touches the workpiece and
secure it with the plunge locking lever
• Raise the depth stop for the depth of cut required,
using the scale. Clamp in place with the thumb knob.
The gap between the depth stop and the turret stop
screw determines the depth of cut.
The depth stop includes a micro adjustment facility.
• For fine depth adjustment, turn the micro adjuster knob
at the top of the depth stop
• To increase the depth, turn the head anti-clockwise. To
decrease the depth, turn the head clockwise 1 rotation
= 1mm
WARNING:
DO NOT change the turret stop
while the router is running. This will place your hands too
near the cutter head.
CAUTION:
Ensure that the plunge locking
lever is unlocked. Never use unnecessary force to rotate
the fine height adjuster mechanism.
CAUTION:
Turn the router on before plunging
the cutter head into the workpiece.
MAINTENANCE
Your power tool has been designed to operate over a
long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
tool care and regular cleaning.
WARNING:
To reduce the risk of serious
personal injury, turn tool off and disconnect
tool from power source before making any
adjustments or removing/ installing attachments
or accessories. An accidental start-up can cause
injury.
Repairs
WARNING:
To assure product SAFETY and
RELIABILITY,repairs, maintenance and adjustment
(including power cord repairs, and brush inspection and
replacement, when applicable) should be performed by a
EN - T1
Trend service centre or a Trend authorized service centre.
Always use identical replacement parts.
Lubrication
• Your power tool requires no additional lubrication.
Cleaning
WARNING:
the main housing with dry air as often as dirt is seen
collecting in and around the air vents. Wear approved
eye protection and approved dust mask when
performing this procedure.
WARNING:
harsh chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the materials
used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
Optional Accessories
WARNING:
those offered by Trend Tool Technology Ltd, have not
been tested with this product, use of such accessories
with this tool could be hazardous. To reduce the risk of
injury, only Trend Tool Technology Ltd recommended
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.
Storage
• After use return the tool to its storage box.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing as
waste.
Accessories and packaging should be sorted
for environmental-friendly recycling.
Separate collection. This product must not be disposed
of with normal household waste.
Household User
Local regulations may provide for separate collection
of electrical products from the household, at municipal
waste sites or by retailer when you purchase a new
product. Please call Trend Customer Services for advice
as to how to dispose of unwanted Trend electrical
products in an environmentally safe way or visit
www.trend-uk.com
-19-
Blow dirt and dust out of
Never use solvents or other
Since accessories, other than