Publicidad
Idiomas disponibles
Idiomas disponibles
The ashing light indicates when you should replace the lter:
Green:
The water lter is ltering optimally.
Yellow: It will soon be time to change the water lter. Think about
purchasing a new one!
Red:
Please change the water lter!
You can check your lter status at any time by pressing briey on
the BRITA Smart Light.
BRITA Memo J K
Remove the protective foil before using BRITA Memo for the rst
time.
After activating the water lter, press and hold the „START" button
until four bars appear on the display and ash twice.
The ashing dot in the bottom right of the display unit means:
"Memo in operation".
A new water lter is required if the empty display unit ashes.
Changing the MAXTRA PRO water lter L
7
Simply remove the water lter and follow steps 1 to 6 of the
instructions.
Important information
Never place the BRITA water lter jug and the MAXTRA PRO
water lter in full sun and keep away from heating elements
(e.g. kettles or conventional ovens).
It is better to store them in a dark, cool and dry place (and keep
new water lters in their original packaging). Store the BRITA
Smart Light out of the reach of children (risk of swallowing)!
Sensitive to potassium?
Filtering initially causes a slight elevation in the potassium content
of the water. This is harmless (e.g. 1 L of BRITA ltered water
contains less potassium than an apple).
Please consult your doctor before using a BRITA water lter if
you suer from kidney disease or have to follow a special low-
potassium diet.
Natural traces
The BRITA activated carbon beads are of natural origin and so
natural variations may occur.
A low volume of small carbon particles can get into the ltered
water, which you may see as black particles.
These particles are not harmful to your health because they pass
naturally through the body unchanged if swallowed.
If you discover carbon particles in your ltered water, BRITA
recommends rinsing the water lter until there are no more
particles visible.
Publicidad
