Black and Decker NHT518 Manual De Instrucciones página 7

been dropped, run over o rdamaged inany way(i.e., p ierced with a
nail, h itwith a hammer, stepped on). D amaged battery packs s hould
bereturned toservice c enter forrecycling.
Z_ CAUTION: When not
in use, place tool on its side on a stable
surface where it will not cause a tripping or falling hazard. Some
tools with large battery packs will stand upright but may be easily
knocked over.
Battery Cap Information
A battery storage and carrying cap is provided for use whenever the
battery is out of the toot or charger. Remove cap before placing
battery in charger or tool.
Ax
_lr'_ |_ | |_ll _1: Fire hazard. Do not store or carry
battery so that metal objects can contact exposed battery
terminals. For example, do not place battery in aprons, pockets, tool
boxes, product kit boxes, drawers, etc., with loose nails, screws,
keys, etc. Transporting batteries can possibly cause fires if the
battery terminals inadvertently come in contact with conductive
materials such as keys, coins, hand tools and the like. The US
Department of Transportation Hazardous Material Regulations (HMR)
actually prohibit transporting batteries in commerce or on airplanes
(i.e., packed in suitcases and carry-on luggage) UNLESS they are
properly protected from short circuits. So when transporting individual
batteries, make sure that the battery terminals are protected and well
insulated from materials that could contact them and cause a short
circuit.
IMPOF ANT CHARGING SAFETY
INSTRUCTIONS
CHARGING PROCEDURE
THE BATTERY PACK IS NOT FULLY CHARGED AT THE
FACTORY. CHARGE BATTERY PACK FOR AT LEAST 9 HOURS
BEFORE USE.
The charger is designed to use standard household 120 volt 60 Hz
power.
1. Plug the charger into any standard 120 Volt
60 Hz electrical outlet (figure 1}.
2. Slide the charger onto the battery pack as
shown in figure 2 and let the battery pack
charge initially for 9 hours. After the initial
charge, under normal usage, your battery
pack should be fully charged in 6 to 9 hours.
2a) During charging the green LED will appear.
2b) When charging is complete the green LED
will go off.
3. Unplug charger, and remove the battery pack.
Place the battery pack into the tool until it
"clicks" into place.
NOTE: To remove the battery pack, press
down on the release button on the back of the
battery pack and slide out (figure 3).
IMPORTANT CHARGING NOTES
1. After normal usage, your battery pack should be fully charged in
6 to 9 hours. If the battery pack is run-down completely, it may
take up to 9 hours to become fully charged. Your battery pack
was sent from the factory in an uncharged condition. Before
attempting to use it, it must be charged for at least 9 hours.
2. DO NOT charge the battery pack in an air temperature below