SOLAC OPTIMA START 2200 CERAMIC Instrucciones De Uso página 7

DRY IRONING
• The appliance has a steam flow regulator (C) that permits
dry ironing (without steam) when placed in the minimum
position.
STEAM IRONING
• It is possible to iron with steam whenever the deposit is
filled with water and an adequate temperature is selected.
STEAM FLOW CONTROL
• The appliance has a regulator knob (C) that allows getting
control of the steam flow.
SPRAY
• The spray can be used in both steam and dry ironing.
• Press the spray button (A) to use this operation.
• The spray button has to be pressed repeatedly to release
the first spray.
STEAM BLAST
• This function provides extra steam for eliminating
wrinkles.
• Press the steam blast button (B). Wait a few seconds
until vapour penetrates the fibres of the garment before
pushing the button again. For optimum steam quality, do
not apply more than three successive blasts.
• The steam blast button has to be pressed repeatedly to
release the first shot.
VERTICAL STEAMING
• It is possible to iron hanging curtains, items of clothing on
his hanger, etc. To do so, follow the instructions.
• Select the maximum temperature of the iron while turning
the temperature regulator of the iron in a clockwise
direction.
• Move the iron in a top-to-bottom direction while pressing
the steam blast button (B). Important: For cotton and
linen, it's recommended to put the iron base in contact
with the material. For other more delicate fibres, it's
recommended to keep the iron base at some centimetres
of distance.
ONCE YOU HAVE FINISHED USING THE APPLIANCE
• Select the minimum position (MIN) using the thermostat
control.
• Unplug the appliance from the mains.
• Allow to cool.
• Remove the water from the inside of the appliance.
• Clean the appliance.
CLEANING
• Disconnect the appliance from the mains and allow it to
cool before undertaking any cleaning task.
• Clean the equipment with a damp cloth with a few drops
of washing-up liquid and then dry it.
• Do not use solvents or products with an acid or base pH,
such as bleach, or abrasive products, for cleaning the
appliance.
• Never submerge the appliance in water or any other liquid
or place it under running water.
SELF-CLEANING FUNCTION
• It is important to self-clean the appliance at least once a
month to remove calcium and any other built-up minerals
inside the iron.
• Fill the deposit to its maximum level, as indicated in the
«Filling with water» section.
• Place the iron in the vertical position, plug it into the
mains and select the maximum temperature.
• Leave the appliance to heat up until the pilot light
indicates that it has reached its consigned temperature.
• Unplug the appliance and place it in the sink.
• Move the steam regulator control (C) to the right and keep
it pressed on the self-clean position. (Fig. 2).
• Let the water flow out through the steam vents in the base
while lightly shaking the appliance.
• Release the steam regulator after a minute or when the
tank is empty.
• Leave the iron in the vertical position until it has cooled.