Publicidad
Idiomas disponibles
Idiomas disponibles
III
1
L i
3
Preparation
• Use Type ! (normal) tapes only.
• Set the tape to the point where recording will start.
1 Insert the tape to be recorded on into deck 1.
Insert the tape with the side to be recorded on first facing out
from the unit.
ll/A
2 Press function
(CD, TAPE,TUNER
orVIDEO/AUX)
and prepare
the source
to be recorded.
To record from a CD press CD and load the disc(s).
To record from a tape, press TAPE. Then insert the original
tape into deck 2 and play it.
To record from a radio broadcast
press TUNER/BAND and
tune, in to a station.
To record from a connected source, press VIDEO/AUX.
3 Press •
to start recording.
I_ is depressed simultaneously.
When recording from a connected source, start playback of
the :source.
When
the selected
function
is CD, playback
and recording
start simultaneously.
To stop recording, press I/_
on deck 1.
To pauLserecording, press II on deck 1. To resume recording,
press it again.
To record selected tracks of the CD
Before pressing •,
program the tracks (see page 9).
To start recording precisely (except when recording from
a CD)
Before pressing • at step 3 above, press II on deck 1. Then,
press •.The
deck enters recording pause mode. To restart
recording, press II again.
To record part of the CD
When • is pressed, recording always starts from the first track.
To start in the middle of a track, play the CD first and press |1 for
CD at the point to start recording from. Then, press •.The pause
mode for CD is released automatically and recording starts.
About cassette tapes
• To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
Side A _j
Tab for side A
To record on the tape again, cover the tab openings
with
adhesive
tape, etc.
• 120-minute
or longer
tapes
are extremely
thin and easily
deformed
or damaged.
They are not recommended.
• Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism.
Do not press the buttons on deck 2 during recording.
J
z
O
Ill
Sound adjustment during recording
The output volume and tone of the speakers or headphones are
freely varied without affecting the recording.
To erase a recording
1 Insert the tape to be erased into deck 1 and press TAPE.
2 Set the tape to the point where the erasure is to be started.
3 Press • to start the erasure.
ENGLISH 11
Publicidad
