Publicidad
Idiomas disponibles
Idiomas disponibles
Fuel Filter
Air Cleaner
Gasoline a nditsvapors areextremely f lammable and explosive. Fire
or explosion cancausesevere burnsor death.
,
Keep gasoline awayfrom sparks, openflames, pilot lights, heat,
and other ignitionsources,
•
Check fuel lines,tank, cap, and fittings frequently for cracks or
leaks. Replaceif necessary.
•
Before replacingthe fuel filter,drain the fuel tank as per the
instructions below.
•
Do not drain fuel when the engine is hot.Allow the engine
adequate time to cool. Drainfuel into an approvedcontainer
outdoors, awayfrom open flame.
,,
Drain any large volumeof fuel from the tank by disconnecting the
fuel line from the in-line fuel filter near the engine.
•
Remove the fuel line from the In-lineside (side towards the fuel
tank) of the fuel filter.
,
Replacement parts must be the same and installedin the same
position as the original parts.
•
If fuel spills, waituntil it evaporatesbefore starting engine.
•
Before replacingthe fuel filter, drain the fuel tank.Otherwise,fuel
can leak out andcause a fire or explosion.
To Drainthe fuel:
I.
Locatethe fuel filter,which isroutedon the left sideof the engine
betweenthe fueltank andthe carburetor,and maybe attachedto
the enginewith a tie strap. Cutthe tie strap, if present,then pinch
the in-lineclampon the fuel filter with a pairof pliers,slidethe
clamp up the fuel line.Pullthe fuel linefree from the filter and place
the open endof the line into an approvedcontainerto drainthe fuel.
To change the fuel filter:
1.
Use pliers to squeezethe tabs on the other clamp (the out-line
side of the fuel filter), then slide the clamp awayfrom the fuel filter,
Twistand pullthe fuel line off of the fuel filter.See Figure11.
2.
Check the fuel linesfor cracks or leaks. Replace if necessary.
3.
Replacethe fuel filter withan original equipment replacement
filter. Call 1-800-4-MY-HOME@ to purchasethe originalequip-
ment replacement filter.
4.
Securethe fuel lines withthe clamps.
Clamp
Fuel
Line
Tab
If filters,or covers arenotinstalled correctly sedous injuryor death
couldresultfrombackfire. D onotattempt t ostarttheengine with
themremoved.
Donotusepressurized air or solvents to clean theair cleaner
cartridge.
Theair filtersystemusesa cylindrical cartridge. Thismodelalso
includes a pre-cleaner thatcanbewashed andreused.
1. Remove thefasteners (A)andtheair filtercover (B),SeeFigure 12.
2.
Toremove thefilter(C),lifttheendofthefilterandthenpullthefilter
off theintake(D).
3.
Remove thepre-cleaner (E),if equipped, fromthefilter.
4.
Toloosendebris,gentlytapthefilteron a hardsurface, i f thefilter
is excessively d irty,replacewitha newfilter.
A
Figure 12
J
5.
Wash the pre-cleaner in liquid detergent andwater.Then allow it
to thoroughly a ir dry. Do not oil the pre-cleaner.
6.
Assemble the dry pre-cleanerto the filter.
7.
Installthefilter on the intake.Pushthe endof the filterintothe baseas
shown. Make surefilter fits securely inthe base.
8.
Install air filter cover and secure with fasteners.
Figure11
....
J
2O
Publicidad
