GE Profile WPDH8850 Manual Del Propietario E Instalación página 7

ge.corn
PRE
WASH
Prewash
Prewash is an extra wash before
the main wash, Use it for heavily soiled
clothes or for clothes with a care label
that recommends prewashing before
washing, Be sure to add high-efficiency
detergent, or the proper wash additive
to the prewash dispenser.
The prewash feature will fill the washer
(adding the prewash detergent), tumble
the clothes, drain and spin. Then the
washer will run the selected wash
cycle.
NOTE: In some special cycles,
the prewash is selected automaticallb!
as the default. You can modifb! this
selection at any time.
EXTRA
Extra Rinse
Use an extra rinse when additional
rinsing is desiredto remove excess dirt
and detergent from soiled loads.
NOTE: In some special cycles, the extra
rinse is selected automaticallb! as the
default. You can modi&j this selection at
anb! time. Some cycles have additional
rinses done automaticallb!.
DELAY START
ii (: ti¸::
Delay Start
You can delay the start of a wash cycle
for up to 2/4 hours. Press the DELAY
STARTbutton to choose the number
of hours you want to delay the start
of the cycle. Use the • and • (up and
down) arrows to find the desired delay
time; then press ENTER to select the
delay time. Finally, press the START
button after the desired cycle is
selected. The machine will count
down and start automatically
at the correct time.
NOTE: If SOUforget to fullb! close
the door, a reminder signal will beep
reminding Sou to do so.
NOTE: If Sou open the door when the
delab! is counting down, the machine
will enter the pause state. You must
close the door and press START again
in order to restart the countdown.
LOCK
Push to LOCkControl
Hold 3 Seesto Unlock
Lock
You can lock the controls to prevent
any selections from being made. Or
you can lock or unlock the controls
after you have started a cycle.
Children cannot accidentallb! start
the washer bb! touching pads with
this option selected.
To lock the washer, press and hold
the LOCK button for 3 seconds.
To unlock the washer controls,
press and hold the LOCK button for
3 seconds. A sound is made to indicate
the lock/unlock status.
The control lock icon on the display will
light up when it is on.
NOTE: The POWER button can still be
used when the machine is locked.
®
Hold3 Secs
to Store
MY CYCLE (on some models)
To save a favorite cycle, set the desired
settings for wash cycle, soil level, spin
speed and wash temp settings and
hold down the MY CYCLE button for
3 seconds. A beep will sound to indicate
the cycle has been saved.
To use your custom cycle, press
the MY CYCLE button before washing
a load.
To change the saved cycle, set
the desired settings and hold down
the MY CYCLE button for 3 seconds.
NOTE: When using MY CYCLE,
wash options cannot be modified
after the cycle has been started.
NOTE: If Sou change wash options
with MY CYCLE before starting the cycle,
the MY CYCLE light will turn off and Sou
will be returned to the base cycle.
7