HEATSTRIP THG2400BA-EU Manual De Instrucciones página 12

MOUNTING
Fix the two mounting brackets to the ceiling or wall in the desired location (refer minimum bracket centre chart). Make sure
the method of fixing (bolts or screws) will be more than strong enough to support the weight of the heater, allowing for
strong winds and other conditions.
•
Slide the 2 locking brackets into the groove on the back of the heater. Make sure the pins on the locking bracket are
facing the matching holes in the top mounting bracket.
•
Lift heater into position and secure the 2 locking brackets to the mounting brackets using the screws provided. Make
sure the 2 pins on the locking bracket engage with the matching holes in the mounting bracket. The pins will allow for
both horizontal or angle mounting as required
•
Tighten all screws and tighten the round nut at the top of the bracket, so it locks onto the top part of the mounting
bracket.
NOTE: The standard bracket allows for normal or angle mounting of the heater and is suitable for ceiling or wall mounting.
MODEL
THG2400BA-EU
THG3200BA-EU
"B"
MINIMUM DISTANCE (mm)
350
700
Left: Suspension mounting, using the standard
mounting brackets
NOTE: Chains or wire not included