Publicidad
Idiomas disponibles
Idiomas disponibles
Trim kits and decorator panels.
For CustomStyle ''_models
Read these instructions
completely
and carefully.
GEAppliances.com
Before You Begin
Some models ore equipped with trim kits that allow you to install door ponds. You con order pre-cut block, white,
bisque or stainless steel decorator ponds from GE Ports and Accessories, 800.626.2002,
or you con add wood
ponds
to match your kitchen cabinets.
Panels less than 1/4" (6 mm) thick
When installing wood panels less than 1/4" (6 mm) thick, you need to create a filler panel, such as 1/8" cardboard, that will fit
between the face of the door and the wood panel. If you are installing the pre-cut decorator panels, pre-cut filler panels are included
in the kit.The combined thickness of the decorator or wood panel and the filler panel should be !/4" (6 mm).
Panels 1/4" thick or less
3/4" (19 mm) or Raised Panel
A raised panel design screwed or glued to a 1/4" (6 mm) thick backing, or a 3/4" (19 mm) routed board can be used. The raised
portion of the panel must be fabricated to permit clearances of at least 2" (5.1cm) from the handle side for fingertip clearance.
Panelsthicker than !/4" (6 mm), up to 3/4" (19 mm) max, will require that the outer 5/16" (8 mm) of panel perimeter be no thicker
than !/4" (6 mm).
Weight limitations for custom panels.
Fresh Food if8 Ibs.(! 7 kg) max.
FreezerDoor 28 Ibs.(!5 kg)max.
Panels thicker than 1/4" 16mm)
5/16" (8 mm)
1/4" (6ram) max
3/4" (19 mm)
2" (5.1 cm)
Clearance
Handle Side
Panel
I
1/4" (6 mm)
Thick Backing
3/4"
(19 mm)
Refrigerator
Door
21
Publicidad
