GE Profile 22 Manual Del Propietario E Instalación página 43

Performance Data Sheet
SmartWater Filtration System-GE ® MSWF Cartridge
This system has been tested and certified in filter model GEMSWFaccording to NSF/ANSI S tandards 42 and 53 for reduction of the substances listed below.
The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water
leaving the system, as specified in NSF/ANSI S tandards 42 and 53.* (Safety factors built in for unmetered usage.}
Parameter ' USEPAMCL
Standard No. 42: Aesthetic effects
I I influentChallenge .
Effluent %Reduction
Concentration Average ' Maximum ' Average Maximum Min. Required Reduction
2.0 mg/L ± 10% 0.06 mg/L 0.10 mg/L 97% 9.1% > 50%
at least 10,000 particles/ 408,333 670,000 95.5% 89.4% > 85%
mL
Standard No. 53: Health effects
.... ' in"uentCha,enge .... Emuent
Parameter ' USEPAMCL Concentration Average Maximum Average Maximum
! NTU.... 11+ 1 NTU.... 0.38 NTU 0.S NTU 96.5% 95.4%
99.95% Reduction Minimum 50,000 L < 1 #/L 4 #/L > 99.99% > 99.99%
0.010 mg/L 0.15 mg/L ± 10% < I ppb < 1 ppb 99.3% 99.3%
0.010 mg/L 0.15 mg/L ± 10% 3,i ppb 9.0 ppb 98.0% 95.5%
0.002 mg/L 0.006 mg/L ± 10% 0.34 ppb 0.7 ppb 94.0% 89.6%
0.002 mg/L 0.006 mg/L ± 10% 0.66 ppb 1.5 ppb 88.4% 73.7%
0.0002 mg/L 0.002 mg/L ± 10% < 0.02 ppb < 0.02 ppb > 99.0% > 99.0%
0.003 mg/L 0.009 mg/L ± 10% <0.5 ppb < 0.05 ppb > 93.9% > 94.3%
0.070 mg/L 0210 my/L_+ 10% 7.7 ppb 35 ppb 96.0% 82.0%
0.003 mg/L 0.015 mg/L _+ 10% < 1 ppb < 1 ppb >92.9% > 92.9%
0.005 mg/L 0.015 mg/L ± 10% < 0.S ppb < 0.5 ppb >96.8% > 97.0%
0.040 mg/L 0.080 mg/L ± 10% < 1 ppb 1 ppb > 98.7% > 98.7%
0.075 mg/L 0.225 mg/L _+10% < 0.5 ppb < 0.5 ppb > 99.7% > 99.8%
99% Reduction 107 to 10 8fibers/L; < 0.17 HF/L <0.17 MF/L > 99% >99%
fibers > 10pro in length
*Testedusing pressure of 60 psig;pH of 7.5± 0.5;temp of 680± 5%120 ° ±2.5°C}.
**Measurement in Particles/mL. Particles used were 0.5-1microns.
***Based onthe useof Cryptosporidium parvum oocysts.
.... NTU=NephelometricTurbidity Units
Capacity 300 gallons 11,135 liters). Contaminant reduction determined by NSFtesting.
% Reduction
:
Max, Permissible
Product Water
0.5 NTU
99.95%
0.010 mg/L
0.010 mg/L
0,002 mg/L
0,002 mg/L
0.0002 mg/L
0.003 mg/L
0.070 mg/L
0,003 mg/L
0,005 rng/L
0.040 mg/L
0.075 mg/L
99% Reduction
Application Guidelines/Water Supply Parameters
ServiceFlow Water Pressure
WaterSupply Water Temperature
It is essentialthat the manufacturer'srecommended installation,maintenanceand filter replacementrequirementsbe curriedout for the productto perform asadvertised.
See insert for Warranty information.
Operating Specifications
®Pressure requirement: 40-120 psi (2.8-8.2 bur), non-shock
• Temperature: 33-100°F (0.6-38°C)
• Flow rate: 0.9 gpm (3.14 Ipm)
General Installation/Operation/Maintenance Requirements
• Flush new cartridge at full flow for 4-1/2 gallons (about five minutes} to purge
trapped air.
• Replace cartridge when flow becomes too slow.
• Protect from freezing by removing filter cartridge when temperatures ore
expected to drop below 40°F (4.4°C). Do not install systems in areas where
ambient temperatures may go above 100°F or below 40°E Do not install
on a hot water supply.
Special Notices
• Installation instructions ore included with the product when shipped.
, This drinking water system must be maintained according to manufacturer's
instructions, including replacement of filter cartridges.
• Do not use with water that is microbio)ogicaUy unsafe or of unknown quality with-
out adequate disinfection before or after the system. Systems certified for cyst
reduction may be used on disinfected water that may contain filterable cysts.
• The contaminants or other substances removed or reduced by this water
treatment system are not necessarily in your water.
, Check for compliance with the applicable state and local tows and regulations.
. Note that while the testing was performed under standard laboratory conditions,
actual performance may vary. Systems must be installed and operated in
accordance with manufacturer's recommended procedures and guidelines.
• Installation and use MUST comply with all state and local plumbing codes. Do not
install if water pressure exceeds 120 psi. If your water pressure exceeds 80 psi
(552 kPa), you should install a pressuredimiting valve. Contact a plumbing
professional if you ore uncertain how to check your water pressure.
Do not install where water hammer conditions may occur. If water hammer
conditions exist you must install a water hammer arresten Contact a plumbing
professional if you are uncertain how to check for this condition.
. Where a backflow prevention device is installed on a water system, o device for
controlling pressure due to thermal expansion must be installed.
For conditions of use, health claims certified by the California Department of Public
Health, and replacements, see performance data sheet. California Department
of Public Health Certification #06-1834. The contaminants or other substances
removed or reduced by this water filter are not necessarily in oil users' water.
Tested and Certified by NSF International against ANSI/NSF Standards 42 and 53 in model GE MSWF for the reduction of:
Standard Na. 42: Aesthetic Effects
• Chemical
- Chlorine Taste and Odor
• Mechanical Filtration
- Particulate Reduction, Class I
GE
Appliances
Appliance Park
Louisville, KY 40225
geapplianceparts.com
Standard No. 53: Health Effects
, Chemical Reduction
- Atrazine Reduction
- Endrin Reduction
- Benzene and Corbofuron Reduction
- 1,4 Dichlorobenzene and
2,4-D Reduction
- Lead and Lindane Reduction
- Mercury and Toxophene Reduction
• Mechanical Filtration
- Cyst and Asbestos Reduction_-_
REPLACEMENT ELEMENT
EPA#10350-MN-005
© 2010 General Electric ComDanv PC61577C
43