MPM MKE-12 Manual De Instrucciones página 29

ERROR TABLE: CAUSES AND SOLUTIONS
ERROR CAUSE
CODE
E0 No pot/pan in the heating zone. Incorrect cookware.
E1 Electrical failure/ short circuit.
E2 Damaged temperature sensor.
E3 Power supply voltage too high.
E4 Power supply voltage too low.
E5 Ceramic hob or cookware temperature too high. Empty
cookware.
E6 Cooling fan(s) damaged.
CLEANING AND MAINTENANCE
Clean the device after each use. Disconnect the device and wait until it gets cooler. Do
not use petrol, thinners, brushes and paste to clean the device. Wipe the device with
damp cloth with some dishwash. Using the vacuum cleaner remove the dirt from the air
ducts and the fan grid. Clean the ceramic surface and the control panel with soft cloth and
delicate means for cleaning ceramic surfaces. Take care and prevent running water on the
device (water may cause the damage of the device). Never immerse the device and the
power cord in water or other liquid.
TECHNICAL DATA
Technical parameters are indicated on the product nameplate.
Length of power cord: 1,25 m
Noise level: L
= 48 dB
WA
NOTE! MPM agd S.A. reserves its right to modify the technical data.
Proper disposal of the product (waste electrical and electronic equipment)
Marking on the product indicates that after the service-life of the product expires, it should not be dis-
posed with other type of municipal waste. Used equipment may have a negative impact on the environ-
ment and health of people due to potentially containing hazardous substances, mixtures and components.
Mixing electric waste with other types of waste or disassembling those in an unprofessional manner may
cause a release of substances that are hazardous to the environment and health. Used equipment should
be handed-over to a point for collection of electric waste. In order to obtain detailed information regarding the
electric waste collection points, the user should contact the municipal point of electric waste collection or used
equipment processing department.
SOLUTION
Put a pot/pan in the heating zone. Make sure your
cookware is compatible with induction hobs.
Contact an authorised service centre.
Contact an authorised service centre.
Make sure the power supply parameters correspond to
the ones presented on the product's nameplate.
Make sure the power supply parameters correspond to
the ones presented on the product's nameplate.
Wait until the temperature of the hob/cookware goes
down. Fill the cookware.
Turn off the appliance. Wait until it cools down, clean
the airflow grills and turn on the hob again. Contact an
authorised service centre.
EN
29