Publicidad
Idiomas disponibles
Idiomas disponibles
Panel Fan
3
Information
3.1
Overview
1 Housing / Square wall plate
2 Intake guard (optionally available accessory)
3 Electric motor
4 Motor rating plate
5 Fan rating plate
Pictures used in this instruction may deviate from your actual product as
various motor and impeller models are used in this fan series.
Identification of the product
A rating plate is permanently attached to the Panel Fan and it must not be
removed.
The rating plate displays electrical, mechanical and identification information.
Each fan has a unique 14-digit numerical serial number which is listed on the
rating plate. The serial number must be provided in any future
correspondence regarding this fan as it is the unique information used for
identifying the fan in question.
A QR-code is displayed on the rating plate. This QR-code contains a link to
an information page about this product. Here you can find a digital copy of
these instructions as well as other information about this product.
3.2
Intended use
This Panel Fan is intended for use in general ventilation systems. The rugged
design makes this Panel Fan especially suitable for general industrial and
agricultural ventilation. Example applications are factories, workshops and
pig, poultry and dairy barns.
This Panel Fan is for mounting on a wall or ceiling.
NOTICE
This fan is intended for moving air only.
INS00002- B
Original instructions
DANGER
Do not use this fan in explosive or potentially explosive at-
mospheres.
3.3
Technical information
For detailed technical information please visit our website from which
technical datasheets can be viewed and downloaded.
http://productselector.vostermans.com
3.4
Other information
DANGER
Ventilation system failure
This fan is manufactured to the highest quality standards. Neverthe-
less, failure of a fan can always occur.
This fan is intended to be used as a component of a ventilation sys-
tem. Where the health and well-being of humans and/or animals is
dependent on the functioning of this ventilation system, an appropri-
ate backup system must be provided such that in the event of failure
of the main system, sufficient air renewal is guaranteed to preserve
the health and well-being of the humans and/or animals.
An alarm system, which will operate even if the principal electricity
supply to it has failed, must be provided to give warning of any fail-
ure in the system.
4
Installation
► Before commencing installation
1. Check the fan after you have received it and make sure it has not been
damaged during transport.
2. Briefly rotate the impeller and/or motor shaft by hand to make sure they
rotate freely.
3. Check all the information on the rating plate and verify that this fan is
suitable for the intended application.
4.1
Mechanical
This fan can be installed in any orientation. Always use all four holes in the
wall plate corners to fasten the fan to the wall or ceiling.
Condensate drain holes
The fan motor has drain holes to allow condensation that may form inside the
motor to leave the motor. After installation, the drain hole at the lowest point
of the motor must be open, the other drain holes must be closed.
Spare condensate drain plugs are supplied with the fan. Keep all the drain
plugs as they must be temporarily reinserted in the open drain holes during
wet cleaning.
Illustration 1: Condensate drain plug
Always install the fan as such that the condensate drain holes are at the
lowest possible position.
ENGLISH (US) | 5
Publicidad
