Publicidad
Idiomas disponibles
Idiomas disponibles
Operation instructions for controller
Note:
During heating operation of the unit, the setting temperature of zone 1 is higher than zone 2; during cooling operation of
the unit, the set temperature of zone 1 is lower than zone 2. If the temperature of the later adjustment exceeds the limit,
the temperature in another area will change accordingly.
For example, in the heating mode, the set temperature of zone 1 is 45 °C, and the set temperature of zone 2 must be
less than or equal to 45 °C. If the set temperature of adjustment zone 2 is 48 °C, the set temperature of zone 1 will
automatically change to 48 °C.
If a third-party controller is selected, the setting temperature of the point displays "Link", and the controller cannot change
the set temperature, the temperature is determined by the third-party controller.
Menu
Tap the lower left menu icon , It will show the following interface:
1. Schedule
① Add
Tap on "SCHEDULE" in picture 6. If schedule has been set, the set of schedule information is displayed. If you enter
schedule for the first time, it will be blank like below.
Tap the "+" icon in the center of the screen or the icon at the lower right corner, and tap "ADD" to add a new schedule.
You can set schedule on (start) and off (end) time, mode, temperature, and cycle days, etc.
Picture 6
Picture 7
36
Publicidad
