Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
4.
Cutting line
trimmer/edger. When the cutting line needs replacing,
insert a new spool (not included) or rewind new line
onto existing spool.
CAUTION: To avoid injury, always remove
the battery before installing the guard, changing a
cutting line, or making any adjustments.
4a. To remove the spool:
a.
Remove the battery from the trimmer.
b.
Turn the string trimmer/edger over to access the
spool.
c.
Remove the spool cover (L) by pressing on the two
tabs parallel to each other on the sides of the
spool cover (L).
d.
Remove the spool (M) from the spool
housing (O).
4b. To replace the spool:
a.
Replace the spool (M) with a new pre-wound
spool (not included) or a re-wound spool.
b.
Insert the ends of the line through the line
openings in the spool cover (L).
c.
Align the tabs on the spool cover (L) with the slots
in the spool housing (O) on the trimmer head.
d.
Push down on the spool cover (L), locking it to the
spool housing (O).
4c.
To refill the spool:
a.
Cut a length of 0.080 in. (2.0 mm) nylon line
approximately 25 ft. (8 m) long.
b.
Bend the line at the midpoint and hook the loop
into the slot in the center rim of the spool (M).
Ensure line snaps into position in the slot.
c.
direction. Once completed, put the line in the slot
so it does not unwind.
d.
Do not wind the line beyond the edge of
the spool (M).
4a
on the grass
4b
4c
12
O
O
L
M
L
M
M
Publicidad
