Publicidad
Idiomas disponibles
Idiomas disponibles
Using your Dishwasher..continued
=. "Refill
Rinse Aid" Indicator
Fill the Rinse Aid dispenser when the Refill Rinse Aid message
comes on as shown in Figure 23.
b) Wait at least ten seconds or until water noises stop before
opening
the dishwasher
door.
c) To resume the cycle, shut the dishwasher
door and press
the On/Off button.
23
4. "Sanitized"
Indicator
The Sanitized indicator appears on the control panel display as
hown in Figure 24.
6. Canceling
or Changing
a Cycle
a) To cancel or change a cycle, press and hold for three
seconds the two buttons labeled "Cancel Drain" as shown ir
Figure 25 until the digital readout shows
"0".
25
24
_hen the Sanitized indicator lights, it means that your dishes
have been sanitized
according to very strict standards of wash
time and water temperature.
The standards for sanitization
are
set by the National Sanitation
Foundation (NSF) and are
explained in the document
ANSI/NSF
184, Residential
Dishwashers.
More information
on NSF standards
is available
at the NSF website http://www.nsfconsumer.org/home/
appliances.asp.
The dishwasher
cycles that are NSF certified are Scrub Wash,
Normal Wash, and China Gentle. When these cycles are
complete, the "Sanitized"
indicator on your dishwasher
control
panel will illuminate.
Note: If your household water supply is too hot, your
dishwasher's
heating time may be reduced and the "Sanitized"
light or symbol may not illuminate. Your dishwasher
Installation
Manual has information
on the recommended
temperature
for
your household
hot water supply.
5. Interrupting
a Cycle
NOTE: Should you need to interrupt a cycle (to add or remove an
item, to add detergent, etc.), it is best to do so within the first 30
minutes of the cycle.
a) Press the On/Off button to stop the dishwasher.
b) Wait for approximately
one minute, then press the On/Off
button
c) You may now begin a new cycle.
E. Wash Cycle
Options
1. Top Tier Only
TM
Cycle
This option allows you to save energy and water by washing
loads small enough to fill only the top rack.
Note: The Top Tier Only option does not reduce wash time
To use the Top Tier Only cycle
a) Load the top rack.
b) Press the On/Off button.
c) Press the button for the desired wash cycle.
d) Press the Top Only button.
2. Delay
Start
This option allows you to delay the start of the selected wash
cycle for up to 24 hours.
a) Press the On/Off Button
b) Press and hold for three seconds the Delay Start button as
shown in Figure 26 until the LED display shows the number
of hours of delay desired.
26
SCALD HAZARD: You could be seriously scalded if you
open the dishwasher
door quickly during a wash or rinse
cycle. Do not fully open the dishwasher door for at least
10 seconds after the dishwasher
has stopped, or until
water noises stop.
c) Press the button for the desired wash cycle. You can change
the delay time and/or the cycle at any time during the delay.
10
Adding Detergent and Rinse Aid
Operating
the Dishwasher
Publicidad
