ADE CK 2303 Instrucciones De Operación página 35

9. Use + or - to set the desired time span for the
snooze function (time span between two alarms).
Choosing "OFF" disables the snooze function.
10. Repeat the procedure described above to set the
second alarm time likewise.
11. If you do not need a second alarm time, press
ALARM SET repeatedly until you return to the
normal display.
Switches the alarm function on/off
‚ Alarm 1: Push the switch on the rear from
to .
‚ Alarm 2: Press the AL2 button.
‚ Watch the display in each case.
‚ Once the alarm function is enabled, the display
shows the set alarm time for a few seconds.
You can also check the set alarm time by briefly
pressing the ALARM SET button repeatedly
(proceeding from the normal time display).
Waking up
At the set time, you will be woken by an alarm signal,
which will become more intense as the waking time
increases.
Auto-stop function
If you do not press a button, the alarm switches off
automatically after 2 minutes.
After 24 hours, the alarm will be triggered again.
CK 2303 DCF radio-controlled alarm clock
35