Publicidad
Assembly
Assembling Dust Bag
1.
With the miter arm locked in the down position, push
the dust bag 1 onto the dust port 2 to collect sawdust.
(Figure 5).
2.
Position dust bag 1 so that it does not interfere with the
tool during the cutting operation for all miter/bevel
settings.
3.
The dust bag requires emptying when full of sawdust.
Empty it frequently and after completion of sawing.
Carefully remove dust bag from dust port. Empty dust
bag in proper trash bin by unzipping the bag. Zip the bag
before installing on the dust port. Be extremely careful of
dust disposed, materials in fine particle form may be
explosive. Do not throw sawdust on an open fire.
Spontaneous combustion, may in time, result from
mixture of oil or water with dust particles.
When sawing chemically pressure treated
WARNING
!
lumber, paint that may be lead based, or
any other materials that may contain carcinogens, use
special precautions. A suitable respirator must be worn by all
personnel entering the work area. Work area should be
sealed by plastic sheeting and persons not protected should
be kept out until work area is thoroughly cleaned.
2
32
FIG. 5
1
Publicidad
