Publicidad
Idiomas disponibles
Idiomas disponibles
Wireless Remote Controller (Heat Pump Model)
The controls will look like the following.
15
5
4
2
8
ON
OFF
14
9
13
11
Operation Mode
Cooling Operation
Auto Operation or Auto Changeover
Healthy Dehumidification Operation
Heating Operation
NOTE
To use the functions printed in blue at the bottom of the buttons press 2
button. Pressing the 2
nd
press the 2nd F button again else it will automatically cancel if remains idle after 10 seconds.
Signal transmitter
1
3
13
CANCEL
10
SET
7
AUTO CLEAN
6
12
16
Flip-up door
(opened)
F button activates the blue printed function of the respective button. To cancel the function
ON/OFF BUTTON
Used to turn off/on the unit.
OPERATION MODE SELECTION BUTTON
Used to select the operation mode.
ROOM TEMPERATURE SETTING BUTTONS
Used to select the room temperature.
INDOOR FAN SPEED SELECTION BUTTON
Used to select fan speed in four steps low, medium,
high and natural wind.
HORIZONTAL VANE CONTROL BUTTON
Used to set the desired vertical airflow direction.
AUTO CLEAN BUTTON
AUTO CLEAN
Used to set auto clean.
ROOM TEMPERATURE CHECKING BUTTON
Used to check the room temperature.
ON/OFF TIMER BUTTONS
Used to set the time of starting and stopping operation.
ON
OFF
TIME SETTING BUTTONS
Used to adjust the time.
CANCEL
TIMER SET/CANCEL BUTTON
Used to set and to cancel the timer operation.
SET
RESET BUTTON
Used prior to resetting time.
LED LUMINOSITY BUTTON (OPTIONAL)
Used to adjust LED luminosity.
SLEEP MODE AUTO BUTTON
Used to set sleep mode auto operation.
AIR CIRCULATION BUTTON
Used to circulate the room air without cooling or heating.
JET COOL BUTTON
Used to start or stop the speed cooling.
The Jet Cool operates fan in super high speed
in cooling mode.
2nd F BUTTON
Used prior to using modes printed in blue at the bottom
of buttons.
F button first and then the required function
nd
Operating Instructions
Owner's Manual 11
Publicidad
