Publicidad
Idiomas disponibles
Idiomas disponibles
10.
Upon completion of this process the display will indicate the
measured resistance value, the elapsed time, the test current
and (on BSG mode) the ground current.
11.
The unit of measured resistance shall be expressed in Ω (ohms),
mΩ (mili-ohms) or µΩ (micro-ohms).
12.
This information can be saved in the internal memory during and
/ or after the test simply by pressing the save key
13.
To finish the test press the red stop key
product with the power switch
button
14.
Finally, after all measurements have been completed, switch the
device off using the on / off switch
Display on AUTO or MANUAL mode
Display on BSG mode
.
16
.
. Do not turn off the
without pressing the stop
.
Publicidad
