Functions Assigned To The Controllers - Edirol UR-80 Manual Del Usuario

Controlling your software

Functions assigned to the controllers

Please affix the Logic labels to the included template sheet. The explanation below will follow these settings.
Track Control section
Track faders
These adjust the level of each channel.
By switching the fader bank you can adjust the level of all channels.
* Use the FADER BANK function buttons to switch fader banks.
Master fader
Control the master volume of Audio Mixer.
Track Status buttons (TRACK STATUS/HQ PART)
These buttons switch the status of each channel.
By switching the fader bank you can control the status of all channels.
* Use the FADER BANK function buttons to switch fader banks.
Mode SELECT button status
MUTE OFF
SOLO GREEN
REC/RDY RED
SELECT ORANGE
Track control knobs (TRACK/HQ CONTROL)
These knobs function as encoders.
The value will increase while the track control knob is turned toward the right, and will decrease
while the knob is turned toward the left. The change (increase/decrease) will stop when you return
the knob to the center position.
Use the ASSIGNMENT function button to switch the parameters that are controlled by these knobs.
Automation button (AUTOMATION)
This switches the automation mode of the currently selected channel.
AUTOMATION button status
READ
WRITE
TOUCH
LATCH
44
Function
Switch channel mute on/off. On: lit Off: unlit
Switch channel solo on/off. On: lit Off: unlit
Switch channel record-ready on/off. On: lit Off: unlit
Select the channel to which an operation for an individual channel will apply.
Selected: lit Not selected: unlit
Operable channel/track
Switch the automation mode to READ
Switch the automation mode to WRITE
Switch the automation mode to TOUCH
Switch the automation mode to LATCH