SAKAWA CS2500 Manual Del Usuario página 89

Assembly.
The chainsaw contains the elements indicated in the illustration.
26. Bar protector
27. Chain protector
28. Guide bar
29. Chain
30. Screwdriver for carburetor adjustment
Open the box and install the guide bar and chain on the power unit as follows:
ATTENTION: the teeth of the chain are very sharp, use suitable gloves as a protective measure.
Move the protection to the previous grip to verify that elf reindeer chain has not been used.
Loosen the nuts and remove the chain cover, fix the suspension connecting rod on the rear of the
power unit using screws
NOTE: Make sure to mount the chain in the correct direction in the direction of movement
Adjust the chain tensioner nut inside the bottom hole of the guide bar. Then install the chain cover
tighten the mounting nut with your fingers.
NOTE: Make sure the hook is fully fitted to the hind limb when the chain cover is installed.
Tighten the nuts tightly, keeping the guide bar facing upwards. Then verify that the chain moves
easily and that the tension of the chain is correct, moving it with your hand. In case it is necessary
to adjust it again after loosening the chain cover. Then adjust the tensioner screw.
NOTE: New strings expand slightly when used the first few times. Check the chain tension
frequently. If the chain is loose it can come out.
89