Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR:
USER
2.
GENERAL INFORMATION
This instruction manual for use, installation and maintenance is
to be considered an integral part of the heat pump (hereinafter
referred to as "device").
The manual describes the installation procedures to be ob-
served for correct and safe operation of the device, and the
methods of use and maintenance.
The manual must be kept with the device for future reference
until it is dismantled and must, in any case, always be available
to qualified installation and maintenance personnel.
If the device is sold or passed on to another user, the manual
must accompany it to its new destination.
For the EXPERT TECHNICIAN/ MANUFACTURER'S
TECHNICAL ASSISTANCE ONLY.
The manual describes the installation methods to be followed
for correct and safe operation of the device and maintenance
interventions.
Before installing the equipment, carefully read this in-
struction manual and in particular chapter 8 on safety.
Symbols are used throughout the manual to find the most im-
portant information more quickly (paragraph "4.3 DESCRIP-
TION OF THE SYMBOLS USED IN THE MANUAL AND ON
THE PACKAGING" on page 161).
136
EN
EXPERT TECHNICIAN /
MANUFACTURER'S TECHNICAL
ASSISTANCE
cod. 3540000420 - Rev. 03 - 09/2023
EGEA TECH
2.1
RECIPIENTS OF THE MANUAL
It is intended for the specialist installer (installers - mainte-
nance technicians) and the end user.
To distinguish the content of the manual based on the char-
acteristics of the recipient (user and expert technician), the in-
structions are divided as follows:
RECIPIENT OF THE INSTRUCTIONS
Person who uses the device under normal
conditions.
This symbol (where present) indicates that
the information and instructions are in-
USER
tended for them.
ATTENTION! This symbol (where present)
indicates that the information and instruc-
tions are not intended for them.
For each type of intervention, the user
must contact the EXPERT TECHNICIAN /
USER
MANUFACTURER'S TECHNICAL ASSIS-
TANCE.
Person in charge of installation and main-
tenance.
The technician has access to all the infor-
mation contained in this manual.
Any
equipment must be performed
EXPERT
by qualified personnel. Exclu-
TECHNICIAN /
sively for interventions on the
MANUFACTUR-
refrigeration circuit, including
ER'S
disposal, the personnel must
TECHNICAL
be equipped with a suitable re-
ASSISTANCE
frigeration technician's licen-
se aimed at the knowledge and
management of systems contai-
ning gases of the HFC type.
In case of doubts about the cor-
rect interpretation of the instruc-
tions contained in this Manu-
ATTENTION
al, contact the manufacturer's
TECHNICAL ASSISTANCE
receive the necessary clarifica-
tions.
200 HT - 260 HT
intervention
on
the
to
Publicidad
