Publicidad
Idiomas disponibles
Idiomas disponibles
8.11
COMMISSIONING
To commission the device, perform the following operations.
8.11.1 Preliminary checks
Check that the device has been
connected to the ground cable.
OBLIGATION
Check that the line voltage cor-
responds to that indicated on the
device plate.
ATTENTION
Check that the device is free from
tools or utensils of various kinds.
VISUAL IN-
If present, remove them.
SPECTION
8.11.2 General cleaning
•
Do not pour or spray water on
the product.
•
Do not clean the surfaces with
PROHIBITION
easily flammable substances
(for example: alcohol or paint
thinners).
Clean only the external surface
using a soft and dry cloth.
MANUAL
CLEANING
8.11.3 Commissioning of the plant
• Fill the tank completely via the inlet faucet and check that
there are no water leaks from gaskets and connections.
• Do not exceed the max. permissible pressure indicated in the
"general technical data" section.
• Check the water circuit safety devices.
• Plug the unit into the power outlet.
• When the plug is inserted, the unit is OFF.
To turn on the unit, refer to paragraph "3.5.1 Power on" on
page 140
In case of a sudden power outage, when restored the equipment
will restart from the operating mode prior to the interruption.
182
EN
8.11.4 Query, editing operating parameters
This
equipment
ing
and
For details, refer to chapter "3. USE OF THE WATER HEATER"
on page 138.
NB!: Use of the password is reserved for qual-
ified personnel; any consequences due to
incorrect parameter settings will be the sole
responsibility of the customer. Therefore,
any interventions requested by the customer
from an authorised technical assistance cen-
tre FERROLI during the standard warranty
period, for product problems due to incorrect
settings of password-protected parameters,
will not be covered by the standard warranty.
9.
REPLACEMENTS
ATTENTION
EXPERT TECHNICIAN
ATTENTION
ATTENTION
cod. 3540000420 - Rev. 03 - 09/2023
EGEA TECH
has
distinct
modifying
the
Incorrect repairs may put the
user in serious danger. If your
device needs any repair, con-
tact the technical assis-
tance service.
Any intervention on the equi-
pment must be performed by
qualified personnel. Exclusi-
vely for interventions on the
refrigeration circuit, including
disposal, the personnel must
be equipped with a suitable
refrigeration technician's li-
cense aimed at the knowledge
and management of systems
containing HFC type gases
Before undertaking any main-
tenance operation make sure
the equipment is not and can-
not accidentally be electrically
powered.
Therefore, turn off the de-
vice and remove the plug
from the socket.
Carrying out repair work on
parts with safety function
compromises safe operation
of the equipment. Only replace
defective parts with original
spare parts.
200 HT - 260 HT
menus
for
consult-
operating
parameters.
Publicidad
