Descargar Imprimir esta página

Remington RM1632A Manual Para El Usuario página 13

Sierra eléctrica
Ocultar thumbs Ver también para RM1632A:

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING
CHAIN SAW
4.
Remove din, stones, loose bark, nails, staples, and
wire from tree where you will make felling cuts.
5.
Stay on uphill side when telling tree. Tree could
roll or slide downhill after falling.
Felling Procedure
A) Felling Notch
A properly placed felling notch will determine
direc-
tion tree will fall. Place telling notch on side of tree in
direction you want tree to fall (see Figure 12). Follow
directions
below to create a telling notch.
1. Make
lower notch
cut as close to ground
as
possible.
Hold saw so guide bar is horizontal.
Cut 1/3 the diameter
of tree trunk (see Figure
12). Note:
Always
make this horizontal
lower
notch cut first. If you make this cut second, tree
can pinch chain or guide bar.
2.
Start upper notch cut the same distance
above
first cut as first cut is deep.
Example:
If lower notch cut is eight inches deep,
stall upper notch cut eight inches above it. Cut
downward at 45 ° angle. The upper notch cut should
meet end of lower notch cut (see Figure 12).
3.
Remove
tree trunk wedge created
by notching
cuts.
B) Felling Cut
1. Make felling cut two inches higher than lower
notch cut and on opposite side of tree (see Figure
12). Keep telling cut parallel to lower notch cut.
3rd Cut -
Felling
Cut
\
\
2"(5cm)
Hinge
I_.Direction
of Fall
2nd Cut - Upper Notch Cut
1st Cut - Lower Notch Cut
Figure 12 - Felling A Tree
2. Cut towards notch.
3. As t_lfingcut nem_ Nnge, tree shouMbegin to t:aH.
Note: If needed, drive wedges into felling cut to
control direction of fall. If tree settles back and
pinches chain, drive wedges into fdfing cut to re-
move saw.Only use wedges made of wood, plastic,
or aluminum. Never use wedge made of steel. This
couM cause kickback and damage to chain.
4. When tree begins to fall, quickly
• remove saw fiom felling cut
• release trigger to turn saw off
• put saw down
• exit area using retreat path
,_
WARNING:
Do not cut aH the way
through
tree. Leave about
two inches
of tree diameter
uncut
directly
behind
felling notch (see Figure 12). This uncut
portion acts as a hinge. The hinge helps
keep tree from
twisting
and falling
in
wrong direction.
13

Publicidad

loading

Este manual también es adecuado para:

Rm1635w