Publicidad
Idiomas disponibles
Idiomas disponibles
How to make the batteries perform longer
(1) Recharge the batteries before they become
completely exhausted.
When you feel that the power of the tool becomes
weaker, stop using the tool and recharge its battery. If
you continue to use the tool and exhaust the electric
current, the battery may be damaged and its life will
become shorter.
(2) Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately after
use. If such a battery is recharged immediately after
use, its internal chemical substance will deteriorate,
and the battery life will be shortened. Leave the
battery and recharge it after it has cooled for a while.
PRIOR TO OPERATION
WARNING
To avoid serious accident, ensure the switch is
in the OFF position, and pull out the battery.
1. Preparing and checking the work environment
Make sure that the work site meets all the conditions
laid forth in the precautions.
2. Power switch
Ensure that the power switch is in the OFF position.
If the battery is installed while the power switch is in
the ON position, the power tool will start operating
immediately, which could cause a serious accident.
3. Changing application tools
CAUTION
● Never touch the application tool with bare hands
immediately after use. The metal is hot and can
easily burn your skin.
● The lever is attached to a strong spring. Be very
careful not to get your fingers caught when
pushing the lever down.
NOTE
○ Make sure the facing of the application tool is correct.
○ Make sure the application tool is properly set on the
protrusion of the attachment ring.
(1) Pull the lever up. (Fig. 8)
○ Fully open the lever to the position shown in the
figure.
Lever
(2) Pull out the tool shaft while rotating it
counterclockwise. (Fig. 9)
1
(3) Attach the application tool to the attachment ring,
making sure the tool's hole is fitted to the ring's
protrusion. The angle of attachment for the
application tool can be set in 30° increments. (Fig. 10)
(4) Firmly insert the tool shaft while rotating it clockwise.
(Fig. 10)
Sanding Paper
Tool shaft
2
1
Blade
Ring's Protrusion
(5) Push down the lever. (Fig. 11)
English
Tool shaft
Fig. 8
Tool shaft
2
Fig. 9
Tool shaft
2
Pad
Fig. 10
3
1
13
Publicidad
