MTD 490-241-0032 Manual De Instrucciones página 6

11. Your clamps can be partially pre-assembled.
The clamp assembly that mount to your unit may be
oriented horizontally or vertically.
The preferred orientation of the clamp assembly is to
have the saddles perpendicular to one another. Thread
the small bolt P into the center of K & L assemblies,
fi nger-tight. Slide smaller tube, L, into larger tube, K.
12. To determine the general location and direction for
the crossbar (J), have an assistant hold the cab at the
desired location over the unit.
NOTE: Depending on your unit, the crossbar may be
positioned facing forward or backward, and above
or below any linkage.
13. Notice how crossbar will sit in clamp assemblies once
clamps are mounted on unit.
NOTE: If the controls on your snow thrower require more
space for proper operation, fl ip bar J. Make sure open end
of crossbar is facing up. Be sure end with tab is facing
down.
14. Holding crossbar (J) in desired location, select area
to mount K & L clamp assemblies . See Fig. 12.
NOTE: Brute and John Deere units may require you to
mount to the horizontal handlebars on the unit.
NOTE: Preferred position is on the vertical portion
of the unit's upper handlebars.
6
Lower Handle Bars
(Horizontal Tube Mount)
K
L
Upper vertical Lower horizontal
handle bars
L
K
K
Upper Handle Bars
(Vertical Tube Mount)
OR
P
L
Crossbar (J)
handle bar
J
K
OR
L
J
K
K
L
L