MTD 490-241-0032 Manual De Instrucciones página 7

15. Take pre-assembled K, L & M clamp assemblies. Mount
assemblies K & L in the determined location on unit. Use
plates M and large bolts N, lock washer T and nuts R to
secure K, L & M assemblies to unit. Now tighten small
bolt P so both clamp assemblies extend equal distance
from frame.
NOTE: Location of lock washer T should be
underneath nut R.
N
M
N
16. Place crossbar (J) against assembly K & L. Center
crossbar (J) against unit. Use two remaining M plates,
large bolts N, lock washer T and nuts R to secure
crossbar. See Figure 15A.
NOTE: Make sure open end of crossbar is facing up.
Be sure end with tab is facing down.
T
L
T
R
Fig. A
P
M
L
Upper vertical
handle bars
Lower horizontal
handle bar
M
J
K
K & L
M
Open End
Tab
7