Fagor FG055 Manual De Usario página 13

(2) position for storage。
CORDLESS IRONING
7. Set the 3-position switch to (1)position.
8. Take the iron(without power unit)from the stand.
9. Always replace the iron on the stand during ironing intervals.
10. When the iron is correctly placed on the stand, the pilot light (F)will illuminate.
11. If the soleplate needs heating up to the set temperature, the pilot light(F)will also be
activated. As soon as the soleplate has regained the set temperature, this light will cut
out.
12. We advise you to use the iron in the corded position if you intend to steam iron for a length
of time and when you apply numerous shots of steam, as this can cause the soleplate to
cool down considerably.
HOW TO CLEAN AND STORE
⚫ After using, lift the iron with the filling hole downwards to empty the remaining water from
the water tank.
⚫ Insert the plug into the socket, and set the Temperature Control Dial to "MAX" for 1-2
minutes to evaporate the remaining water, and then unplug the iron and let it cool down .
The ironing after using fixed at (2) for storage.
⚫
ATTENTION:
When the plug connecting with the power socket, the user is not allowed to leave.
When the power cord is damaged, contact your dealers or an authorized service center for
repair.
In case of any repairs, replacement of cord or plug, or adjustment, please consult a qualified
technician, or take appliance to an authorized service facility.
REMOVAL OF APPLIANCES USED
Directive 2002/96/EC on waste electrical and electronic Equipment (WEEE)
requires that the appliance uses are not disposed of using the normal municipal
waste. Old appliances must be collected separately in order to optimize the
recovery and recycling of materials they contain and reduce the impact on
human health and the environment.
The symbol of the dustbin is used on all products to remind the obligations for separate
collection. Consumers should contact their local authorities or dealer regarding the steps to
follow for the removal of their old appliance. If you proceed with the scrapping of old
equipment, be sure to render useless what could be dangerous: disconnect the power cable
flush with the device.
Danger:
Never attempt to use your appliance, if it shows signs of damage or the power cord or plug is
damaged. If the power cord is defective it is important to have it replaced with the after sales