Steam Ironing; Dry Ironing - Fagor FG055 Manual De Usario

STEAM IRONING

⚫ When heating the sole plates, put the steam switch « off »
⚫ Place the iron in a vertical position and set the temperature control dial at the
minimum/low heat setting.
⚫ Insert the plug into the socket, and then turn the temperature control dial to the "high
heat" marking. The pilot light will come on, indicating that the iron is heating up.
⚫ When the pilot light turns off, the set temperature has been reached and the iron is ready
to use.
⚫ During ironing, the pilot light on the iron automatically switches on/off as the thermostat
maintains the set temperature(you may continue ironing during this process).
⚫ Turn the steam control turning knob to the required position.
⚫ Steam is produced as soon as the iron in held horizontally.
SPRAYING
⚫ Until heating complete, don't open the button of burst steam or continue steam, because
the water will be spill out, if the temperature of soleplate is not heating enough.
Press the spray button to spray water on clothes, as often as required.
⚫
Note: When using the water spray function, ensure that there is enough water in the water
tank, and you may have to pump the spray button several times at first time you use the iron
in order to start the spraying function.
BURST OR VERTICAL STEAM IRONING
⚫ Press the burst of Steam button to generate a powerful burst of steam that can penetrate
the fabrics and smooth the most difficult and tough creases. Wait for a few seconds
before pressing again.
⚫ During use the continue steam function, don't press the button of burst steam, prevent
the soleplate temperature is too low and cause leakage.
⚫ By pressing the Burst of Steam Button at intervals you can also iron vertically
(curtain,hung garments, etc.)
Note: The burst steam function can only be used at high temperature. Stop the emission
when the pilot light turns on, then start ironing again only after the pilot light has turned off.

DRY IRONING

For ironing without steam, follow the instruction in section "steam ironing", however, the
steam control turning knob should remain in position "OFF" (no steam).
CORDED IRONING
4. Set the 3-position switch to (3) position
5. Take the iron (with power unit)from the stand for IRONING.
6. Replace the iron (with power unit )on the stand after using and set the 3-position switch to