Publicidad
Idiomas disponibles
Idiomas disponibles
iCONTROLDE
:)preajustado en
ajustes. Revise
_tinuaci6n, antes
neoesario, yea
)NTROL
DE
sido preajustado
itar ajustes.
kDOR
do en la fa'brica
_in embargo, se
nor importancia
_sen el combus-
Si el carburador
de motor,
INSTALL
MOWER
AND
DRIVE
BELT
See MOWER
AND DRIVE
BELT AS-
SEMBEY Supplement
Sheet for additional
guidance
on this assembly.
Be sure tractor
is on level surface
and
engage
parking
brake.
1.
Lower attachment
lift lever to it's lowest
position.
CAUTION:
Lift lever is spring
loaded.
Have a tight grip on lift lever, lower it
slowly and engage
in lowest
position.
2,
Turn steering
wheel to the left as far as it
will go and position
mower on right side
of tractor with deflector shield to the right.
- Pivot bar towards
you and insert other
end of bar into hole in rear mower
bracket
(D). Move mower as needed to
insert bar.
- Secure
with washer
and retainer
spring
as shown.
3.
Remove
plastic tie securing
belt, bring
belt forward
and check belt for proper
routing
in all mower pulley grooves.
!
6. ATTACH
MOWER
SIDE SUSPENSION
ARMS
(A) TO CHASSIS-
Position hole
in arm over pin (B) on outside
of tractor
chassis
and secure with washer
and
retainer
spring.
7.
Repeat on opposite
side of tractor.
NOTE:
Be sure mower side suspension
arms (A) are pointing
forward
before slid-
ing mower
under tractor.
4.
Slide mower under tractor
until it is
centered
under tractor.
5.
FIRST
INSTALL ANTI-SWAY
BAR (S).
- From right side of mower, insert
ant-sway
bar into hole in transmission
bracket
(T).
9
Publicidad
