Haier HLTD500AEW Manual Para El Usuario página 12

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ELECTRIC DRYER (U.S. ONLY)





NOTE: The electrical supply for the dryer must conform with local codes and
ordinances and the latest edition of the National Electrical Code, ANSI/NFPA 70.
If the electrical supply available in the intended dryer location does not meet the
above requirements, contact a licensed electrician.
A dryer operating on a 208 volt power supply will have longer drying times than if
it were operating on a 240 volt power supply.
The dryer is not equipped with a power cord. A kit that meets local electrical
codes must be purchased separately. The dryer can be tted with a 3 or
4-wire NEMA 14-30 or 10-30 type SRDT or ST (as required) power cord rated
at 120/240 volt AC minimum, 30 amp, with 3 open-end spade lug connectors
with upturned ends or closed loop connectors and marked for use with clothes
dryers.
A UL listed strain relief must be attached to the dryer to hold the power cord.
Do not use an aluminum wire receptacle with copper-wired power cord and plug
(or vice versa). The proper wiring and receptacle is a copper-wired power cord
with a copper-wired receptacle.
The electrical outlet should be located so that the power cord is accessible when
the dryer is in the installed position.
ELECTRIC DRYER (CANADA ONLY)



NOTE: The electrical service to the dryer must conform with local codes and
ordinances and the latest edition of the CSA C22.1 Canadian Electrical Code Part 1.
If the electrical supply available in the intended dryer location does not meet the
above requirements, contact a licensed electrician.
Do not use an aluminum wire receptacle with copper-wired power cord and plug
(or vice versa). The proper wiring and receptacle is a copper-wired power cord
with a copper-wired receptacle.
The electrical outlet should be located so that the power cord is accessible when
the dryer is in the installed position.
10



Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Hltd500agwHltd500acw

Tabla de contenido