Troubleshooting; Error Codes; Normal Operating Sounds - Haier HLTD500AEW Manual Para El Usuario

TROUBLESHOOTING

ERROR CODES

When the dryer senses an error all machine operations will stop, a series of 4 beeps
will sound and an error code will be shown in the Estimated Time Remaining display.
ERROR CODE
F3
(Short Circuit)
F4
(Heating Element
Problem)
E6
(Air ow Problem)

NORMAL OPERATING SOUNDS

The following sounds are normal during the operation of the dryer.
Tumbling sound: This is normal as the heavy, wet clothes in the dryer are
continuously being tossed around.
Air rushing noise: This happens as the dryer drum spins and the air is rushing
through the dryer drum.
DRYER DOES NOT OPERATE
Check that the dryer is plugged in. The plug may have come loose.
Check that the electrical wall receptacle is of proper voltage. Electric dryers
require a 240 volt power supply.
Check if the circuit breaker needs to be reset, or if the fuse needs to be replaced.
Check that the dryer door is rmly closed.
30
DESCRIPTION
The dryer has detected an
electrical problem that requires a
certi ed service technician
The electric dryer has detected a
problem with the heating element
that requires a certi ed service
technician.
The gas dryer has detected a
problem with the burner.
The dryer has detected that air is
not owing.
POSSIBLE CAUSE AND SOLUTION
Call for service.
Call for service.
Check to make sure the gas
shuto valve is open.
If the valve is open, call for
service.
Make sure the lint screen is clean.
Check your exhaust system for
obvious blockage. If the error
persists, call for service.