Toshiba REGZA RV55 DIGITAL Serie Manual Del Usuario página 35

Input selection and AV
connections
Defining the INPUT and OUTPUT sockets so that
the television recognises connected equipment.
See page 8 for a clear view of the back connection
recommendations.
Most media recorders and decoders send a signal through the
SCART lead to switch the television to the correct Input socket.
Alternatively press the external source selection button
until the picture from connected equipment is shown.
This button must be used to view equipment connected using
the COMPONENT VIDEO INPUT (EXT3).
o
An S in the display e.g. 2S (EXT 2S), indicates the input is set
for an S-Video signal.
Input selection
Use the Input Selection if the television does not switch over
automatically.
a
At any time by pressing
showing all stored programmes and external
B
equipment. Use and
select.
DTV
HDMI1
HDMI2
HDMI3
PC
ATV
NOTE: When in digital mode ATV cannot be
selected, in analogue mode DTV cannot be selected.
To switch between DTV and ATV press the ATV/DTV
button.
HDMI™ displays equipment connected to Input HDMI
on the back of the television.
PC displays a computer connected to Input RGB/PC on
the back of the television.
o
o
a list will appear on screen
Q
b
to highlight and to
1
2
3C
INPUT signal selection
This specifies the type of signal going into SCART 2 (EXT2) on
the back of the television. Please refer to the manufacturers
instructions for the connected equipment.
a
In the SET UP menu press
highlighted, then press
b
C c
With or select either AV or S-VIDEO as the
required input for EXT2.
PC/HDMI1 audio
HDMI1 audio
HDMI setting
EXT2 input
Woofer
Back
MENU
If the colour is missing try the alternative setting.
In order to receive sound from a connected PC, plug the audio
cable into the back of the television (as shown in 'Connecting a
computer' section), then use the PC/HDMI1 audio settings.
a
In the SET UP menu press
highlighted, then press
b
Highlight PC/HDMI1 audio then use
PC option.
NOTE: Selecting the PC option will force HDMI into
digital audio.
HDMI1 audio
If the connected HDMI source does not support digital audio,
plug the audio cable into PC/HDMI1 (AUDIO) on the back of
the television (as shown in the 'Connecting an HDMI™ or DVI
device to the HDMI input' section), then use the HDMI1 audio
a
In the AV connection menu press
HDMI1 audio and using
35
CONTROLS AND FEATURES
b
until AV connection is
Q
.
AV connection
PC
Digital
OK
AV
Internal
Watch TV
EXIT
PC audio
b
until AV connection is
Q
.
c
to select the
settings.
b
to highlight PC/
c
select HDMI1.