Skil 3335-01 Instrucciones De Funcionamiento Y Seguridad página 3

SM 2610957121 05-08 6/5/08
DON'T FORCE TOOL
It will do the job better and safer at the rate for which
it was designed.
USE THE RIGHT TOOL
Don't force a small tool or attachment to do the job of
a heavy duty tool. Don't used tool for purpose not
intended—for example, don't use a circular saw for
cutting tree limbs or logs.
SECURE WORK
Use clamps or a vise to hold work. It's safer than
using your hand and it frees both hands to operate the
tool.
NEVER LEAVE TOOL RUNNING UNATTENDED
Turn power off. Don't leave tool until it comes to a
complete stop.
DO NOT ALTER OR MISUSE TOOL
These tools are precision built. Any alteration or mod-
ification not specified is misuse and may result in dan-
gerous conditions.
Additional Safety Rules for Scroll Saws
For your own safety, do not operate your scroll saw
until it is completely assembled and installed according
to the instructions...and until you have read and under-
stood the following:
1. General Safety Rules ....................................2-4
2. Motor Specifications and Electrical
Requirements ........................................................6
3. Getting to Know Your Scroll Saw ....................9
4. Operating Adjustments ............................10-13
5. Basic Scroll Saw Operations ....................14-16
6. Maintaining Your Scroll Saw..........................17
7. Troubleshooting ..............................................17
8. STABILITY OF SAW
Your Scroll Saw must be bolted securely to a stand or
workbench. In addition, if there is any tendency for the
Scroll Saw to tip over or move during certain opera-
tions, such as cutting long, heavy boards, bolt your
Scroll Saw stand or workbench to the floor.
9. LOCATION
This Scroll Saw is intended for indoor use only.
7:35 AM Page 3
General Safety Rules
Tool Use
Tool Care
AVOID GASEOUS AREAS
Do not operate electric tools in a gaseous or explo-
sive atmosphere. Motors in these tools normally
spark, and may result in a dangerous condition.
MAINTAIN TOOLS WITH CARE
Keep tools sharp and clean for best and safest per-
formance. Follow instructions for lubricating and
changing accessories. Inspect tool cords periodically
and if damaged, have repaired by authorized service
facility. Inspect extension cords periodically and
replace if damaged. Keep handles dry, clean and free
from oil and grease.
Before connecting the tool to a power
!
WARNING
source (receptacle, outlet, etc.), be
sure voltage supplied is the same as that specified
on the nameplate of the tool. A power source with a
voltage greater than that specified for the tool can
result in serious injury to the user, as well as damage
to the tool. If in doubt, DO NOT PLUG IN THE TOOL.
Using a power source with a voltage less than the
nameplate rating is harmful to the motor.
10. PROTECTION: Eyes, hands, face, ears and
body.
TO AVOID BEING PULLED INTO THE BLADE—
DO NOT WEAR: Loose Fitting Gloves
Necktie
Loose Clothing
Jewelry
DO: TIE BACK LONG HAIR
ROLL LONG SLEEVES ABOVE ELBOWS
a. If any part of your saw is missing, malfunctioning,
has been damaged or broken . . . such as the motor
switch, or other operating control, a safety device or the
power cord...cease operating immediately until the par-
ticular part is properly repaired or replaced.
b. Do not cut piece too small to hold by hand.
HINT: When making a very small cut out, always
secure the workpiece to a scrap piece of plywood with
double-faced tape. This way, the work is supported and
your fingers are away from the blade.
3.