Publicidad
Idiomas disponibles
Idiomas disponibles
Step4:InstallDuctwork (Remote or
InlineBlower, I f Used)
[] A.Install the ductwork and remote b lo-
wer(ifused) inaccordance
with the duc-
twork routing p lan developed inStep 1.
[] B.Make sure that t heinstallation
com-
plies with allinstallations
guidelines.
Type
and length o fducting a nd lack ofmake-
upairmay reduce C FM. Also check t hat
the opening where d uct p asses through
outside w ail o rroof h as been properly
flashed and sealed toprevent leakage.
[] C.Ifusing I ntegral Blower, proceed to
Step 5.
[] D.Ifusing R emote orMine Blower, refer
toInstallation
Instructions
with that
model.
[]
The receptacle
should b elocated u nder
thecountertop sothat t he30inch long
power cord from thevent w ill r each i t.
See Figure 8.
The cord should b erouted b eneath the
appliance and away f rom heat g enerated
bythecooktop. Access should n otbe
obstructed byblower, cabinet work,
ductwork orelectrical/gas
utilities forthe
cooktop. Alipower forthevent system
(including
theremote b lower, ifused) is
supplied via thecord totheintake u nit.
The outlet can usually beextended from
another kitchen outlet orhave itsown
circuit from the main service panel.
Donotplug vent c ordinto receptacle
until Step 8.
Step5:InstallElectrical S ervice
[] Check y our l ocal building codes f orpro-
permethod ofinstallation.
IntheU.S., if
there are noapplicable local codes, this
unit s hould b einstalled inaccordance
with theNational Electric Code
ANSI/NFPA
No. 7 0,Current Issue. (In
Canada, installation
must b einaccor-
dance w ith theCAN 1-B149.1 and
.2-
Installation Codes for Gas Burning Appli-
ances and/or local codes).
[] The appliance must be grounded. In the
event of an electrical short circuit, groun-
ding reduces the risk of electric shock by
providing an escape wire for the electric
current. This appliance is equipped with
a cord having a grounding wire with a
grounding plug. The plug must be piug-
ged into an outlet that is properly instal-
led and grounded.
/_k
WARNING - Improper grounding can
result in a risk of electric shock.
Only a qualified electrician, or similarly quali-
fied persons, should make the electrical
connections.
Do not use an extension cord. If the power
supply cord is too short, have a qualified
electrician install an outlet near the applian-
ce.
Step
6: Mount
Vent and Cooktop
[] A. Remove grease filters and any
packing materials from inside the intake.
[] B. Set the vent intake into rear of coun-
tertop opening. Carefully lower it into
position so that the flanges on the rear
sides and edges fully support the unit
hanging from the countertop.
[] C. Hold the unit against the rear of the
countertop opening, and slide the leg
brackets down to meet the bottom of
cabinet. Check and adjust for plumb,
then fasten leg brackets to cabinet with
hardware provided.
Note: Check boxes as tasks are completed.
12
Publicidad
