Publicidad
Idiomas disponibles
Idiomas disponibles
Step7:MountIntegral B lower or
OutletDuctTransition for Remote or
InlineBlower
Integral Blower (see Figures 9and11for
further detail):
[] A.Attach b Iower infront o fround
exhaust outlet with 4-6(depending
on
configuration)
#8sheetmetal
screws.
[] B.Feed cord from blower through s train
relief.
[] C.Secure strain r elief with screws.
[] D.Attach s train r elief todowndraft near
junction box.
[] E.Connect cord todowndraft at6 pin
connector.
[] RConnect blower toductwork,.
[] G.Place t hecook, topincountertop
ope-
ning with therear e dge ofcook, topover-
lapping thefront e dge ofthevent. Make
sure rear e dge ofcook, topdoes not b ind
against front o fsnorkel. FotIow the
manufacturer's
installation
Instructions
forinstaIIing gasket strips, protective
heat t ape (ifrequired), securing thecook-
toptothecountertop
and making the
cook, topelectrical and/or gasconnec-
tions.
Note: Check` boxes a stasks a recompleted.
6 Pin
Connector
Internal Blower
Strain Relief
Fig. 9 - Internal Blower
13
Publicidad
