Hama 00011413 Instrucciones De Uso página 10

D Each device type can be programmed under
any device key, i.e a TV can be programmed
| ®
> A low battery is indicated by two slow LED under DVD, AUX, etc.
flashes after each URC operation. Replace > If you want to control a device, it's not pos-
the batteries to ensure a proper function. sible while the Universal Remote Control is
in the Setup Mode. Exit the Setup mode and
select the device you want to control using
the device selection keys.
> Code saver will protect all your stored set- 5 4 Direct Code Entry
tings and codes during a battery change or
other temporary power failure. Your Universal Remote Control Package contains a
code list. The code list shows 4-digit codes for most
AN device manufacturers in alphabetical order and
5. Setup grouped by device type (e.g. TV, DVD, etc.). If the
device you want to control is covered by the code
list, the Direct Code Entry is the most convenient
entry method.
> To obtain a proper infrared (IR) transmission, 5.1.1 Turn on the device you want to contro
© allways point your Remote control in the ap- 5.1.2 Press the SETUP key until the LED indicator is ©
proximate direction of the device you want permanently lit. |
ДУ, 5.1.3 Select the device you want to control using
the device key (e.g. TV). A successful selection
D Press the "MODE" key to select the seconda- is indicated by the LED with one flash follo-
ry device group :AUX, AMP, DVB-T, CBL (only wed by permanent light.
8 in1 Model). 5.1.4 Check code list for brand and type of the
device you want to control.
> Press the Shift key to operate the blue func 5.1.5 Enter the corresponding 4-digit code using
tion keys. The Shift function deactivates by the 0 — 9 keys. The LED indicator confirms
pressing the Shift key again, or automatically each entered digit via a short flash and turns
after approx. 30 sec. without use. off after the fourth digit.
> No entry for approx. 30 seconds will time out
the Setup mode. The LED indicator shows six (ше ОО
flashes and turns off.
Þ If the code is valid, it is saved automatically
P If code is invalid, the LED indicator flashes
six times and then turns off. Repeat steps
5.1.1 to 5.1.5 or use a different code entry
method.
©
)11413man cs de el en es fi fr hu it nl pl pt ro ru sk sv tr.indd 8 05.04.12 10:2