Publicidad
Idiomas disponibles
Idiomas disponibles
11. Hard Wire Installation
WARNING: Risk of electric shock. Disconnect the power before performing
the following procedures.
IMPORTANT! The area in front of the sensor must be free of objects during the 2
minute learning cycle or the faucet may not function properly.
NOTE: If a hard wired installation is required, the strain relief may need to be
replaced depending on the wire used.
Loosen the terminal block screws and remove the wires from the top terminal
block.
Loosen the outside nut of the strain relief and remove the power cord.
Insert the supply wires through the strain relief and connect to the top terminal
block.
Tighten the nut on the strain relief.
Secure the terminal box cover to the terminal box.
Turn ON the AC supply power.
Secure any excess wire under the deck.
Allow 2 minutes for the sensor to cycle through the automatic sensing distance.
1561536-2-A
Secure any excess
wire under counter.
16
Kohler Co.
Publicidad
