Kohler Oblo K-123B16-SANA-CP Instrucciones De Instalación página 7

3. Route the Cables and Tube
Finished
Wall
Plaster
NOTE: Refer to the Specification Sheet to determine the control box installation
location.
Finish the wall with a 1-3/4" (44 mm) hole for the spout and a 1-1/4" (32 mm) hole
for the sensor cables.
Remove the plaster guard.
Guide the sensor cables and tube from the spout through the mounting bracket
and down to the hole for the control box.
Take care to avoid kinking or damaging the cables and tube.
Kohler Co.
Guard
Ø 1-1/4"
(32 mm)
Ø 1-3/4"
(44 mm)
7
1561536-2-A